Felpro - Rear Main Seal, Silicone, 2 Piece, Small Block Chev
$30.00
Skip to product information
Felpro - Rear Main Seal, Silicone, 2 Piece, Small Block Chev
Felpro
$30.00
| Engine Displacement | 194, 229 (3.8L), 230, 250, 262, 262 (4.3L), 267, 283, 292, 302, 305, 307, 327, 350, 400, 400 Race |
| Engine Family | Chevrolet L6, Chevrolet V6, Chevrolet V8 Small Block |
| Materials/Construction | Silicone, 2-piece |
Product Data
Manufacturer Torque Spec:
- 1. Thoroughly clean all foreign material from block, bearing camp and crankshaft.
- 2. Debur the sharp edge where the seal housing bore meets the mating surfaces of the cap and block. This will prevent “shaving” the back side of the seal during installation
- 3. Install the seal halves with the sealing lip toward the front of the engine
- 4. Offset the seal parting lines 3/8” from the cap and block surfaces.
- 5. Sparingly, apply a thin film of silicone sealer to the seal ends that protrude from the cap and block, and along the chamber at the sides of the cap.
- 6. Lubricate the seal lip and crankshaft with oil or grease. Note: use grease if there will be a long period of time before startup.
- 7. Install the cap and set the crank end play per manufacturers specs.
- 8. Remove any excess sealer that may have squeezed out around the seal and cap
- Test run engine. Check all mating areas thoroughly to determine that all seals hold during operation
Compatible Engines
SBC
Frequently Bought Together
More products by engine
GM 5.7L V8 Small Block LS1 Engine
GM 5.7L V8 Small Block LS1 Engine
GM 6.0L V8 Small Block L77 Engine
GM 6.0L V8 Small Block L77 Engine
GM 6.0L V8 Small Block L98 Engine
GM 6.0L V8 Small Block L98 Engine
GM 6.2L V8 Small Block LS3 Engine
GM 6.2L V8 Small Block LS3 Engine
GM 6.2L V8 Small Block LSA Engine
GM 6.2L V8 Small Block LSA Engine