ARP Head Stud Kit - 234-4317 LS1 LS2 L77 L98 LS3

Name: ARP Head Stud Kit - 234-4317 LS1 LS2 L77 L98 LS3
Brand: ARP
Price: 695.00 AUD
Availability: InStock

In stock

$695.00

Gen III/IV LS Series small block (2004 & later) w/ all same length studs, 8740, 12pt
Kit #: 234-4317

Specifications
Socket Size(s)	3/8 12pt, 9/16 12pt, 1/8 Allen, 3/16 Allen

Product Data

Manufacturer Torque Spec:

1. Inspect all hardware prior to installation. Look for obvious defects or shipping damages. Please call 800-826-3045 with any questions or issues.
2. To ensure proper thread engagement and accurate torque readings, clean all threads in the block. Chase if necessary with ARP Thread Chaser, part number 912-0011 (M11 X 2.0) and 912-0001 (M8 X 1.25).
3. Clean the spot faces on the cylinder head where the washer seats, use of solvent or brake/carb cleaner is recommended.
4. Install the head gasket and cylinder head.
5. Screw the studs into the block hand tight, do not apply torque. The hex broach in the end of the stud is designed to assist with installing/removing the studs from the block, not for applying torque. Install the 8mm studs in locations 11-15.
6. Then, using a clean, dry rag remove all oil from both sides of each washer. The cylinder head and washer mating surfaces must be free of oil/grease/lubricant. Failure to keep these surfaces dry may result in inconsistent preloads.
7. Place the washers over the studs and on to the dry, clean spot faces of the cylinder head
8. Lubricate the stud threads and bottom of the nuts with ARP Ultra-Torque Fastener Assembly Lubricant. Then install the nuts onto the studs and tighten hand tight.
9. Following the manufacturers recommended torque sequence.
NOTE: See instructions that come with bolts or in this products description for torque sequence.